全国服务热线:13600183990

4-wire Smoke Detector with Relay output DC9-28V 继电器烟感

价格 ¥ 55.00 ¥ 50.00 ¥ 45.00
起批量 1-9 10-99 ≥100
手机专享
手机下单更便宜
物流

广东省 深圳市

产品品牌

CST

产品型号

YT142

成交\评价

采购量
- +
(99766件可售)

添加中...

关闭

您可能也感兴趣:

买家服务
支付方式

申请已发出!

    产地
    中国
    是否进口
    工作电压
    9-28(V)
    货号
    142
    品牌
    CST
    报警电流
    45(mA)
    探测角度
    --
    静态电流
    200(uA)
    工作温度
    -10-+50(℃)
    探测距离
    40平方(m)
    发射频率
    0(MHZ)
    适用范围
    基站
    类型
    非编
    型号
    YT142
    安装方式
    吸顶式
    发射距离
    0(m)
    动作距离
    0(mm)
    通讯方式
    有线
    重量
    150(g)
    告警方式
    信号
    订货号
    142
    物料编号
    142
    最小包装数
    1
    主要下游平台
    wish,亚马逊,速卖通,LAZADA,ebay
    主要销售地区
    东北亚,东南亚,欧洲,中东,非洲,北美,南美
    有可授权的自有品牌
    是否跨境出口专供货源
    包装
    吸塑
    使用范围
    居家 店铺 库房 幼儿园……
    尺寸
    103*55mm

     参数中英对照

    中英对照信息开关量烟感

    Smoke Detector with relay output

    型号JTY-GD-DG311N.O:YT142
    供电电源 DC9V~DC28VOperating Voltage Range: 9 to 28VDC Volts Non-polarized
    静态电流 静态电流 ≤200uAStandby Current: ≤200μA@ 24 VDC
    报警电流≤35mAMaximumAlarm Current (LED on: ) ≤35mA@ 24 VDC
    报警浓度  1.06±.26%FT Smoke Alarm Sensitivity: 1.06±.26%FT
    尺寸103x55mmsize 103x55 mm

     

    英文版:

     1. GENERAL DESCRIPTION
    The detectors are photo-electronic detector uses a state of-the-artoptical sensing chamber. This detector is designed to provide open area protection and to be used with most security alarm control panel.
    Two LEDs on each detector provide local 360° visible alarm indication. They flash every six seconds indicating that power is applied and the detector is working properly. The LEDs latch on in alarm. LEDs will be off when a trouble condition exists indicating
    that the detector sensitivity is outside the listed limit. The alarm can be reset only by a momentary power interruption.
    The detector that initiated the alarm condition will have its red LED and relays latched until reset by panel.
    Heat detector and smoke & heat detector combine a photo electronic sensing chamber and a temperature heat detector.
    2. SPECIFICATIONS
    Operating Voltage Range: 9 to 28 VDC Volts Non-polarized
    Standby Current: ≤200μA
    Maximum Alarm Current (LED on): ≤45mA
    Alarm Relay Contact Ratings: 2A@ 24V DC
    Operating Humidity Range: ≤95%RH(40°C±2°C) Relative Humidity, Non-condensing
    Smoke Alarm Sensitivity: 1.06±.26%FT
    Temperature Alarm Sensitivity: 57°C (135°F) A1R (only for with heat sensor)
    Height: 55 mm installed in Base
    Diameter: 103 mm
    WARNING
    TO PREVENT DETECTOR CONTAMINATION AND SUBSEQUENT WARRANTY CANCELLATION, THE SMOKE
    DETECTOR MUST REMAIN COVERED UNTIL THE AREA IS CLEAN AND DUST FREE.
    3. INSTALLATION
    NOTE: All wiring must conform to applicable local codes, ordinances, and regulations.
    INSTALL THE DETECTOR BASE
    1. Open area smoke or heat detectors are intended for mounting on a ceiling or a wall in accordance with the fire standard in your country.
    2. Attach mounting base to ceiling or wall. The base of the detector can be mounted directly onto an electrical junction box such as an octagonal (75mm, 90mm or100mm), a round (75mm), or a square (100mm) box without using any type of mechanical adapter.
    3. Position all wires flat against terminals, and fasten the wires on the terminals, See Figure 1.
    4. Terminals function description:
    Terminal 1: Relay Output -COM
    Terminal 2: Relay Output – NO/NC (default NO)
    Terminal 3: DC Power –
    Terminal 4: DC Power +

     联系电话:13600183990      

    评价

    订购说明

    买家还在看

    联系我们

    地址:中国杭州市滨江区网商路xxx号滨江xx区(310052)

    Tel:(86) 571-xxx8-2088

    Fax:(86) 571-xxx8-2088

    http://www.1688.com

    产品名
    价格
    暂无友情链接